In excavation machines, the buckets are made of solid steel. Blade tightening is important to break down tough materials and avoid wear on the blade as a whole. One way to maximize bucket life is to replace worn parts. You can find the best quality komatsu trackhoe parts at komatsupart.com/komatsu-parts/undercarriage/excavators/ for your vehicle.
In this economic turmoil, this is an expense that most businesses cannot afford. These winter months, when it is not possible to use the excavator as often as possible, can be the perfect time to make the necessary inspections. Here's what you need to check:
1. Perform a visual inspection to find out which wear parts are damaged. For example, check the teeth of the bucket to see if they appear dull or worn, which may occur if they are overexposed. You should also check that the metal has been cut in any way, which can happen if too much force is applied to it.
2. When replacing edges, note that these are usually provided with wear screws. The same is the case with bucket teeth because they are usually bolted or welded. Depending on how it's installed, it's up to you how you want to remove it. If it turns out that consumables are screwed in, you can remove them with a suitable spanner.
However, if it is welded, you will need to use a cutting torch. In some cases, even if the part was originally screwed in, it may have been cut or warped, which means it may need to be removed with a cutting torch.